SamyGO

allright!
that's even better

thx for answer!
Christian

Hi, i have the following TV... Model: UE46D6500 Firmware: T-GASDEUC-1018.0 is it right that i can hack this FW with Hospitality, and after this step i can downgrage to FW T-GASDEUC 1013 ? afther this 2 steps i can use the complete funktions of samygo? - maybe updating to samygo friendly FW <= 1016 ?...

right,

this was also my decission after reading forum & wiki...
it's the old one from my parents an i had to pay 0?
i think i schould be happy with playing movie from usb ...

before i buy my next tv in a few years...i first will read samygo forum...and then i'll order!

thx for
informations

Hi,

i think its point 2 in Factory-Debug-Menu:

factory debug:


but i did not test it yet.

Hi, right, there is no Content-Library...so these hacks will not work for me. as i said i could activate Wise Link Movie through serial connection. I also could activated DLNA in Sytem-Menu, but this makes no sense without a network connection. So if there could be more Options with SamyGo-Software ...

Hi! i have an LE40B579 (CI+) i also have an working ExLink-Cable and successfully enabled WisoLink Movie on this TV with a serial connection. Now my Question(s) 1. is it possible to flash alternative Firmware and use SamyGo Software on it? or roll back to another Firmware? 2. is it generally possibl...

oh, great, i got it. by pressing (1) for Control and (1) again for SubOption an now i have 9 ... (counted as Media Play DB) 10...(counted as Media Play Movie) 11...(counted as Media Play DLNA) 12...(counted as Media Play List) i tried to set up 11 - Media Play DLNA.. the only options i can use now a...

hi! i got my adapter. it's working - after changing rx-tx, as you said. Go to 10 - factory debug an then run service menu there is some options with no description but it have numbers that are equal to the order in tv service menu. now i stuck at this point: run service menu there is some options wi...

okay, i bought This CP2102 USB-TTL-Adapter , now i have to wait 1 or 2 weeks :( ...but okay...and then i will measure this adapter, and if it has 3.3V than i can solder an adapter with a 15-Pin connector. thx for your help - i will be back in 1 or 2 weeks when the adapter has been shipped ;) best re...

hi, i found this site: http://wiki.samygo.tv/index.php5/Ex-Link_Cable_for_C/D_Series you did not use this MAX232 adaptor circuit V2 Board - because of the voltage? - you directly connected the usb-adapter? (i found a chep one: HERE ) and i actually have an adapter like THIS I've measured my USB-RS23...