I updated my previous post. Toggling partitions may be necessary too, well see. Could you do the steps (1 to 4) i suggested you + changing the rs232 bit also?
isn't 0x51D0 rs232 debug enable ? , Shouldn't I have to change 0x51D1 ? On my Soc Eeprom I have 0x51D0 01 So RS-232 is set to UART mode or I'm mistaken ? Should I switch this to 00 Debug ? 0x51D1 01 So watchdog is on , I have to switch this to 00 Sorry, my fault! Of course you have to set 0x51D0 to...
Hi dssenceme, very well described! First let me tell you that i'm no pro in this forum, but played a lot with my tv to get it back to live (mostly with the help if juuso - big THX once more) and did some firmware modifications. Also my tv is an C7700 which differs to d series. But i will try to help...
@dssenceme First i propose to create a new thread for your problem. I have no D series experience so far, but are you sure that there is no exlink plug or something available? In my case it is within the vga plug. (IIRC i got the watchdog bit in my C7700 SoC EEPROM bit changed via I2C access.) @devs...
nroberto13, did you already try to replug all connectors on the board? (be careful for high voltage!!!) You also could try to store the tv in a could/warm place and try to use it again. Just try to power tv on again and again (with long breaks in between to let tv cool down). One more time working w...
The problem you describe there sounds really bad :/ I think juuso is right: Even if you got some exlink debug output that would most probably not help you. For example my tv prints a lot of error message during boot by default so figuring out which chip is defect will still be hard. Also reflowing i...
@nroberto13: From experience of my C7700 i can tell you that micom EEPROM (used for toggling partition sets) is powered in tv's standby. So you should be able to unplug tv from power to stop cyclic reboot and replug power --> tv is now in standby and not yet in reboot loop. You were now able to acce...