this is my first post, so I hope doing it all correctly and you understand my problem.
I have a Samsung UE40C6800 TV-Set, which has the known Problem with the "Dnie"-BGA (Mstar-BGA) with broken/interrupted solderballs.
The Picture was corrupted, but the TV was working so far.
As i got the opportunity to change a bga with a professional bga-station, i ordered a new bga from china, and replaced the old one with that fresh...
Type and writings of that bga are exactly the same... Soldering on the bga-station is completely automatic, so the replacement should be perfect.
But my problem is:
The tv is just power cycling.... No Picture, no light, no sound... Just booting, turning off, booting again...
So my question: is it possible, that this BGA must be preprogrammed or flashed before using?
How, when needed, can this be done? Are there Jtag-Pins etc?
Sorry, but i am a very beginner on these tv-Sets...
Thank you for spending your time and trying to help me
- SamyGO Project Donor
- Posts: 565
- Joined: Tue Aug 23, 2011 9:03 am
- Location: Hamburg
get a uart connector and grab a bootlog from exlink port (pin 11 in vga connector iirc)
FYI: you can close your ssh session with SamyGO with
Code: Select all