Page 2 of 2

Re: LN55B650 - BRICKED GOOD!!!!

Posted: Tue Dec 28, 2010 4:15 pm
by erdem_ua
Image

Re: LN55B650 - BRICKED GOOD!!!!

Posted: Tue Dec 28, 2010 10:04 pm
by erdem_ua
Setup your ExLink configuration. you might have already debug mode enabled but forgotten later...
You needed to close that gate quickly after opening TV. That will enable debug mode.
Just needed to connect those terminals with wire, coin, bolt, or anything conductor. For avoid shot circuit, you might want to use duct tape and paper that will cover other areas...

Re: LN55B650 - BRICKED GOOD!!!!

Posted: Fri Dec 31, 2010 8:14 am
by juusso
Nice video ;)
What you doing wrong in my opinion -
1. Power OFF TV (from electricity)
2. Make short and do not release it
3. Power ON TV
4. Watch what is going on terminal.
If nothing happends
5. Release short connection
6. Watch what is going on terminal.

Re: LN55B650 - BRICKED GOOD!!!!

Posted: Sat Jan 01, 2011 6:59 am
by juusso
I do not know if secure terminal is good (you need use serial connection from com port, not telnet to IP), Check connection settings you use. And you can try putty as terminal...

Re: LN55B650 - BRICKED GOOD!!!!

Posted: Sun Jan 02, 2011 9:54 am
by majonezz
Make sure to select option "handshaking" to none in your terminal program, because tv uses RXD and TXD only, so none of control signals are available.

Re: LN55B650 - BRICKED GOOD!!!!

Posted: Thu Dec 10, 2015 6:39 am
by Godz420
Do you still have this board?