B Series DTS bugs & support

[openikev2]

smartsmurf

Thanks for great work!

I had checked DCA module with few files, and I had found some problems while audio tracks switching:

Code: Select all

1st file, mkv
DTS - ok
DTS - ok
DTS - ok
AC3 - no sound

2nd file, mkv
AC3 - ok
AC3 - ok
AC3 - ok
DTS - no sound

3d file, mkv
DTS - ok
AC3 - no sound
DTS - ok, but after 10 sec
AC3 - no sound

I hope this will help for you in your hard work.

Another problem: if PVR 0.10 had started before DCA then red button does not work.

In any case, thanks again.

Hi,

I suffer of similar issue. Switching between DTS and AC3 tracks seem to not work.

Best regards

[erdem_ua]

Hi
I noticed a couple of people mentioned it and it seems to have been missed, but is there any possibility of a hack to enable DTS passthrough via optical output? My receiver supports DTS and so it would save on CPU usage etc
Many thanks

Okey, I'll do. Wait a minute. I think my receiver doesn't support DTS. Himm. I inspected deeply and realized that I don't have a sound system too.

[erdem_ua]

Hi guys! i have a Samsung 40B550 hack into B650 . The mkv files working correctly but i don't have sound on dts movies.. "Audio Codec not supported"

i read some posts, and i need the sound stereo on tv and DTS pass opticaly from the tv in my home cinema Samsun HT TX35R.

LE40B550A5PXXN has firmware 2009/09/01_002005

i downloaded DCA0.2 , but i don;t know how to put the update in my tv.. don't have lan or wifi..

please tell me if it possible to update via usb or i need to install/setup and usb wifi in the tv and then ..

Thank you!

You have better to look wiki pages to enable console access to your TV. Also those are already answered questions. Search on forum after reading wiki pages.

[erdem_ua]

Enter the http://www.samygo.tv and click the Wiki link. You can find specific step over there.
Notice that here is not your support topic but DTS bugs topic.
cheers