SamyGO

Hey I know it happend to alot of people now it happend to me.
I tried to reset the EEPROM with cable as described on wiki but TV will not power on. No light.
I found the service manual which describe this

4-7-2. Sub S/W (in Factory mode)
If you don't have DDC Manager, Use this method.
1. Into the Factory Mode.
2. Select "SVC". (Use r button.)
3. Select "MICOM UPGRADE off". (use r button.)
4. If message change from "off" to "wait", TV is upgrading Sub S/W. (It takes about 5 min.)
5. If update completes, TV set will booting automatically.

This is the mode I set the TV in. And I was stupid to shut down the TV.
What does Sub S/W mode mean?

Here's picture from service manual.
https://drive.google.com/file/d/0B5n_DC ... sp=sharing

Afterwards comes the first text as I posted 4-7-2. Sub S/W (in Factory mode).....

There's very hard to get a motherboard like this bn41-01666b

Thanks if anyone can help me out.

Rt809f isp programmer+ micom firmware (possible to get... but only if you have programmer...) = tv survive.

nice, so a clean flash will resolve it as if I get the Rt809f isp programmer? and the firmware

More details and almost everything we know here

Found this firmware
UE32D5500_WT61P805.bin
Motherboard looks close to mine,

Found this information in the link you posted

"With help of programmators like postal2/rt809f and other it is enough to connect TV via VGA (or D_SUB if you like). The pinout is: GND-10, SDA-12, SCL-15. Even HDMI is ok for this goal. TV must be in standby mode to have power on all required chips."

Says TV must be in standby mode to have all power.. Problem is the TV is probably not in standby mode since it is not powering up light.
But the processor gets little warm although like it should when TV is on.

Hello Frudda, have you been able to resolve your issue, I too have the same problem - bad micom upgrade. I desperately need to recover my TV. Any help, i would greatly appreciate.