SamyGO

I need to control a Q(7) Modell by IP or serial link for homeautomation purpose. As i understand right, its actual not possible to do that by EXlink, can anybody confirm? Does the Q Models accept WOL Commands to turn it on?
I also tried a lot by HDMI CEC on HDMI1, but the TV doesnt accept these commands. Anynet+ is activated in the settings menue.

Have a look there: EX-Link UART Control

This depends on J Series, not Q. I´m a little bit worried to destroy the EX-Link Port with RS232 instead of 3.3v ttl signals. For example.

All Tizen's are not using TTL (J and above)
https://wiki.samygo.tv/index.php?title= ... M/Q_Series

I can confirm, for Q i use stright rs232 cable, not usb/ttl.

juusso wrote: ↑Wed Feb 21, 2018 9:57 am I can confirm, for Q i use stright rs232 cable, not usb/ttl.

can you also confirm that powerOn by rs232 works?

At least, as long as "Instant ON" and "Always Instant ON" options from service menu are enabled (default), TV is in true power (C-)state BUT it unmounts USB, shutdowns panel, speakers and everything possible (you can see it in Exlink debug output). Given that the principle of standby nowadays is to "consume the less possible power", I've got some doubts on any reason for serial to stay alive

if that fails, i need to move over to turn on the device by hdmicec. But that was my last option, because i already tried to control the device by cec and it doesnt recognize my cec adapter. little bit of hope is left.

Possible i can check late this night or tommorow. If you tell what exactly you need to know

No special needs. Just need to turn on/off the tv for homeautomation purpose. Infrared is no option, because of latency and the same IR code for on/off.