SamyGO

Really sad.

Here isn`t much help from us... Most of bricked C series TV`s were finally repaired by Service...
But your case is a bit different: you have console (even not fully functional).
You could unbrick your device according Wiki - BrickedTV page

Screen is blank:
If your start.sh has been written with errors, TV does not boot properly...

• Unplug TV and wait 30 sec. Plug to AC, power on TV.

This should remove /mtd_rwarea/start.sh. If that did not help, try:

• Connect Ex-Link Cable for C-Series, switch to debug mode:

Code: Select all

10041004

enter:

Code: Select all

31337

or:

Code: Select all

666

or:

Code: Select all

44337794

After each command try reboot tv (unplug power cord and plug it again). If no success, then i do not know any method to get TV working back. Just Service. Warranty shall help your purse

I apologize, i do not have any other suggestion, just call Service...