Re: Telnet accessible in standby and powerconsumption
Posted: Wed Nov 23, 2011 3:19 pm
Energy saver has LCD off function already.
SamyGO
Samsung TV Firmware on the GO
http://forum.samygo.tv/
Telnet accessible in standby and powerconsumption
Page 1 of 2
Re: Telnet accessible in standby and powerconsumption
Posted: Wed Nov 23, 2011 3:25 pm
In stand by mode it eates 13w. I wonder because i red it should be less than 1w...
Re: Telnet accessible in standby and powerconsumption
Posted: Thu Nov 24, 2011 9:50 pm
i can test, but not today. tomorrow.
Re: Telnet accessible in standby and powerconsumption
Posted: Fri Nov 25, 2011 1:50 pm
You mean out of "real" standby mode?viper3k wrote: Would there be a way to get the B650 out of standby mode via network (telnet,upnp,..or?) or via debug menu (exlink cable) ?
Via network: no way.
Via serial/exlink cable: perhaps, check out: http://www.remotecentral.com/cgi-bin/mb ... gi?19083,3 for details.
Re: Telnet accessible in standby and powerconsumption
Posted: Sat Nov 26, 2011 6:47 am
Yes, i can test consumption with a special tool. I heard if you set rs232 to uart, then you can operate TV from ExLink. Try to enter P in stand by mode...