Page 1 of 1

ES5700 Model Number Hacking

Posted: Tue Apr 23, 2013 3:19 pm
by medion1804
Hi Guys,

in the Wiki i read about the possibility of model number hacking -->

Code: Select all

What            ES5700  -->     ES6300
----------------------------------------
CMR             100Hz           200Hz
Full HD 3D      no              yes
Micro Dimming   no              unknown *
WLAN            no              yes **
----------------------------------------
* Catalogues give contradictory information, may only work on models with CMR=400Hz
** If WLAN module is installed by ordering spare-part. The ES5700 FW is already looking for WLAN!
The last entry in the Wiki from 20 December 2012 was -->
Of course, in order to do this you need to:

Change the Model Number and Panel Code in the Engineering Menu
Probably update the firmware to that model

This is work in progress... (more to come)
Now my question: is there any new information about this "project"? ...

I can?t belive that this should be so easy --> changing model number and panel code and updating the FW an everything is fine!?!? or does it?

ty in advance for ur answer :)

best regards

medion

Re: ES5700 Model Number Hacking

Posted: Wed Apr 24, 2013 10:16 am
by JoeyBiggins
Hi Medion,

Iv changed my model version from 7000 to 7500 and 8000 in the service menu (accessible from the remote control) - looking at the serial debug output you can see that the model number has changed but so far no new updates have come through.

Re: ES5700 Model Number Hacking

Posted: Thu Apr 25, 2013 3:44 pm
by medion1804
@joey

ty for ur post :) ... did u notice any changes after changing the model version? ... cause this should be the purpose of the hack, isn?t it? ;)

@"hackers" ;)

any updates regarding my request?

ty in advance

greetz
medion

Re: ES5700 Model Number Hacking

Posted: Wed May 15, 2013 6:14 pm
by samyES5700
Has anyone tried this now? I do not trust myself...

Re: ES5700 Model Number Hacking

Posted: Fri May 17, 2013 6:24 pm
by benschhold
I changed model number to 6300, 3d is working but broken, dont know if u need to update the firmware or change panel to get 200mhz. You have to try