UN32D5500 bricked - original firmware
Posted: Wed Feb 12, 2014 6:09 am
I have a Samsung UN32D5500.
Recently I got a repair service manual for another Samsung product (P2470HN tv monitor), I applied the control remote sequence for the service mode in my smart TV, in the service mode I saw some options but I opted for micon (or similar) option and then the remote control did not respond. Then I unplugged from wall connector the TV, and plugged it again.
The stand-by light does not respond, neither the remote control.
The TV has just the samsung firmware and the internet updates.
What should I do?
What Did I do?
I saw some instructions in the artoicle "UnBricking TV by EEPROM Reset" of the wiki, but I don't know if it corresponds to my (OSI level8) problem.
Thanks a lot.
Recently I got a repair service manual for another Samsung product (P2470HN tv monitor), I applied the control remote sequence for the service mode in my smart TV, in the service mode I saw some options but I opted for micon (or similar) option and then the remote control did not respond. Then I unplugged from wall connector the TV, and plugged it again.
The stand-by light does not respond, neither the remote control.
The TV has just the samsung firmware and the internet updates.
What should I do?
What Did I do?
I saw some instructions in the artoicle "UnBricking TV by EEPROM Reset" of the wiki, but I don't know if it corresponds to my (OSI level8) problem.
Thanks a lot.
