SamyGO

I need help for my Samsung UE32EH4003 Board Modell BN41-01897, Code BN41-01897A

In Wiki Talk:UnBricking TV by EEPROM Reset thre are some Pictures from other EEPROM Locations

i send Pictures for help - more Pics needed, then tell me what Area

thans for your Help
Leesa22

IC901 on last picture?

juuso wrote:IC901 on last picture?

Hello and big thanks

is this ok when i connect Ground to SDA ?

i dont see a VCC Pin near this Area

PS. is my english good enough for unequivocally conversation ?

MfG leesa22

Edit German-time 22.42 13.April 2014

Testet - holding Ground to SDA - next stick in Powercable - waiting over 20 sek - Power unpluged - Power connectet again
TV start again with mirror look and end with --No channels found-- start search-- 5 secounds later shut down and start again.

I dried also with Ground to SCL with no success - Maybe VCC is needed to connect with SDA for success

Can i connect an other VCC Pin on the Board ?

At next i will have a look on the Backside of the Board

MfG leesa22

I found an other VCC Pin on the Board and feel goooooooooooooood


Danke - Grazie - Thanks - nice to have some Profesionals like juuso

Hello
im in need of help my samsung tv keeps restarting it basically shows the samsung logo then restarts
would it be worth trying a EEprom reset ? and if so how can i do this ?
my model number is UE-32EH4003W board number is BN41-01897A

thankyou

Depends on reason. What command or procedure caused boot loop? What last did you when tv stopped to work?

hello thanks for the reply
i done nothing to the tv just turned it on one day and the tv kept restarting

Firmware upgrade failure (unatended, at night). Call service and require warranty repair.

ok thanks for the reply but its run out of warranty

Hello, I have the same problem and the same TV that the partner who created the thread, but I do not understand that you have to bridge to reset, can someone help me?
Thank you