Re: LN40B640 firmware upgrade help
Posted: Sat Aug 28, 2010 8:42 am
Try enter to TOP debug menu. Instruction on wiki. I guess, it should work (if there aren`t any partition deleted), because there is on Your debug log:
If get to serial console, You will be able revert back (i`m not sure if procedure reverting back is exact the same as described on wiki here - i recommend for You manual step-by step method - and compare what You get with instructions on wiki.)
From rows below it seems it is possible to select another partition.
Errors are not important in this log, we all get a lot of errors too.
Try enter bootloader with ~~ just after power-on TV (info: wiki)
You need get to console at first.
Code: Select all
[SERIAL INPUT MANAGE] enable_serial : debug(len: 5)From rows below it seems it is possible to select another partition.
Code: Select all
/mtd_rwarea/PartitionSwitch_0_0 is detected...
1st Partition is selected....Try enter bootloader with ~~ just after power-on TV (info: wiki)
You need get to console at first.
