SamyGO

I've patched my Samsung UE46D6510 with the help of the Hospital Mode Hack, now I get on any start of the TV (after about a minute) a message that a new USB device "SamyGo Virt. USB" has been connected. Is it possible to disable this message somehow?

Which, or more precisely with what you've built this cable Nokia CA-42, or DKU-5, or anything else?
Have you enbled the Debug Mode on you TV?

Ok, finaly it worked.
The problem was apparently the Nokia DKU-5 adapter, now I used the Sparkfun FTDI Basic and thus worked with copy/paste the AT+BAUD8. The Answer from the Modul is OK115200 Hooray, and thanks a lot for you patience, nice that there are so helpful people like you

Thanks again but I do not get the damn thing to run. ;) I built an adapter with a Nokia dku-5 only tx > rx and rx > tx (I don't use the gnd because it cames from the supply voltage and its the same as from the DKU-5), the supply voltage I have connected via a separate USB plug (the module goes from ...

Thanks for reply. I've tried several serial cables and Adapters (Nokia CA-42, DKU-5, Sparkfun FTDI...) I don't get any answer from the BT Module. I tried At Commands and the set Command with putty 9600,8,n,1 but no reaction. This is the Adapter I bought http://cgi.ebay.de/ws/eBayISAPI.dll?ViewItem&a...

ok, a little extra coffee did it. These back-plane ones don't take AT commands, I got it to the correct baud rate with serial command: set baud 115200 Hello I think I have the same Module, how to get it work? What is meanet by "serial command"? Connect a TTL Cable and use a Terminal progr...

For my understanding the description of the pin assignment in the wiki for eXLink cable is incorrect. Pin 4 at the VGA connector is RX (from the TV's point of view) Pin 11 at the VGA connector is TX (from the TV's point of view) Why "from the TV's point of view"? RX is RX of the Adapter an...

No, I have not seen any error message, everything went as described in the instructions on Wiki. After the "clone USB to TV", a window opened the I pressed "OK" and the TV restartet. It could be of course that I have overlooked in this window a info, I can only remind them that t...

Shame on me, the Problem was realy swapped TX and RX lines, I had tested several adapters and so I came a bit confused . I not only can make mistakes, I make them really.
Now the Adapter works very well. Thanks a lot for Help

Yes I know that FTP access is not Samsung like but I performed the hack after the firmware update again, I thought the hack is deleted after a firmware update. That would then not have been necessary?
Then I had luck that this did not break anything.