I have a EH5000 television that I want to control using the rs232 jack plug. I have made myself a cable and when setting the rs232 jack settings to debug I'm able to start a serial connection with baud rate 115200.
Now the screen stays blank afterwards and from the wiki I am able to get into the top debug menu by sending 1198282 and after that sending 20089999.
So the communication works, but now I want to be able to send commands for changing source and commands for power on/off.
What would these commands be and where do I enter them?
I was thinking they should be somewhat in line with starting the top menu, but I have tried several number combinations, but none seem to work!