Issues after Firmware Upgrade - UAEH5000

Here for general support for E series TVs, request and problem solve area.
Post Reply

harold2345
Posts: 2
Joined: Sun Nov 30, 2014 7:32 am

Issues after Firmware Upgrade - UAEH5000

Post by harold2345 »

So I have a samsung 40inches UAEH5000 model and was looking to upgrade the firmware for it.
However, in my hurry to do so, I have installed the firmware for UNEH5000.

The TV installed the update and all and seems to be running fine but with a few issues with HDMI connections.
the 2 HDMI's are swapped now, so HDMI1 is 2 and vice-versa, plus also I need to always connect 2 devices with active HDMI connections, otherwise it just shows no signal.

Any suggestions/help on this will be greatly appreciated...
harold2345
Posts: 2
Joined: Sun Nov 30, 2014 7:32 am

Re: Issues after Firmware Upgrade - UAEH5000

Post by harold2345 »

Anyone ? :D
sulmanalisyed
Posts: 2
Joined: Tue Jun 09, 2020 9:40 pm

Re: Issues after Firmware Upgrade - UAEH5000

Post by sulmanalisyed »

harold2345 wrote: Sun Nov 30, 2014 7:41 am So I have a samsung 40inches UAEH5000 model and was looking to upgrade the firmware for it.
However, in my hurry to do so, I have installed the firmware for UNEH5000.

The TV installed the update and all and seems to be running fine but with a few issues with HDMI connections.
the 2 HDMI's are swapped now, so HDMI1 is 2 and vice-versa, plus also I need to always connect 2 devices with active HDMI connections, otherwise it just shows no signal.

Any suggestions/help on this will be greatly appreciated...
did you found the solution i did same. my now it showing error mesg main board is change go into service menu etcetc. its now settings cable channels. :(

Post Reply

Return to “[E] Support”