[How-To] Alternatives of Samsung WiFi Link Stick

[arris69]

...
# ifconfig
eth0 Link encap:Ethernet HWaddr 00:12:FB:A0:29:AF
inet addr:192.168.1.2 Bcast:192.168.1.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:8856 errors:0 dropped:0 overruns:0 frame:0
TX packets:6169 errors:0 dropped:0 overruns:9 carrier:0
collisions:0 txqueuelen:1000
RX bytes:9525052 (9.0 MiB) TX bytes:867958 (847.6 KiB)
Interrupt:12 Base address:0x6000

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:14753 errors:0 dropped:0 overruns:0 frame:0
TX packets:14753 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:767060 (749.0 KiB) TX bytes:767060 (749.0 KiB)


[/code]

what is the output from dmesg after you plugged the stick in and out (after you loaded the module)?
and try pls. (with stick attached to usb-port):

Code: Select all

ifconfig -a

and

Code: Select all

iwconfig

arris

[arris69]

...

Code: Select all

# dmesg (disconnect/connect)
<6>usb 2-1: USB disconnect, address 2
<6>usb 2-1: new high speed USB device using ehci-s5h2x and address 3
<6>usb 2-1: configuration #1 chosen from 1 choice

...

pls try.
1. turn on tv and start telnet (if it not started automatic) without usb-dongle plugged in
2. make sure rt3070sta and no other rt* module are loaded

Code: Select all

rmmod rt73
rmmod rt....
insmod <dir where module are>/rt3070sta.ko

3. plug your ethernet cable out
4. plug usb-dongle in and wait some seconds (5-10)
5. remove usb-dongle
6. plug ethernet cable again to nw-port on tv
7. try to start telnet session to tv and do an

Code: Select all

dmesg

8. send me whole output of dmesg to arris@zsolttech.com

arris

[erdem_ua]

Arris, could you prepare new WiFi pack? Like 0.3 that includes rt3000 device driver too.
I will go holiday for some weeks. Until I return, you keep an eye on forum

[arris69]

Arris, could you prepare new WiFi pack? Like 0.3 that includes rt3000 device driver too.

its not verified tha the rt3070usb is working and i'm not shure about realy supported devices like d-link w110, seems ralink and samsung made here some strange things.

I will go holiday for some weeks.

holiday, is this something to eat

Until I return, you keep an eye on forum

partial

arris

[erdem_ua]

Hello, I have this question:

Hello, excuse my english, i speak spanish, i have a doubt, if i use the extension: SamyGO WiFi Extension Addon v0.02http://sourceforge.net/projects/samygo/ ... p/download, is the modification of the controllers permanent?, or it is reverted if i extinguish the television, as other extensions of samygo.
Is it reliable?, does it give problems?.
Is it necessary to activate her whenever the tv is ignited?.
Thank you.

Free to try
I can say It's safe to try.

[erdem_ua]

Nop, If you execute them from USB flash...
You can also load required modules via telnet, without installing.
If you have doubts, don't make anything. Just spend another $100 to Samsung for ultra cheap Wifi dongle...
Or you can just try this modules to see if its works.