SamyGO

ok, But it is possible with this cam and tv card operator do it works on my tv???

Anyone with knowledge can answer?Please!!

in general any Hardware CAM should work in TV, but sometimes there are software problems or something else (incompatibility). the only way to be sure is try it, borrow it from a friend or so. but it should work.

Okay, but can you explain why I can not tune the channels of the operator "MEO" satellite: Hispassat on my TV? When I put the the reference channel operator ex: 27500, the tv says no signal! Anyone can help me? ?

Sounds like you dish is not pointing in the right direction? When I tune into scrambled channels, a message pops up on the screen and says signal scrambled, as i dont have a cam card installed.

Can you tune into a free to air channel like Euro news on the same sat?

http://www.lyngsat.com/Hispasat-1C.html says 30000-3/4 8PSK, could be also LNB or cable related, other receiver works?

DEUS wrote:http://www.lyngsat.com/Hispasat-1C.html says 30000-3/4 8PSK, could be also LNB or cable related, other receiver works?

Good day. Yes with other devices linked to the same antenna cable, I can easily tune these satellite channels!

Sammy wrote:Sounds like you dish is not pointing in the right direction? When I tune into scrambled channels, a message pops up on the screen and says signal scrambled, as i dont have a cam card installed.

Can you tune into a free to air channel like Euro news on the same sat?

I, yes i can tune for ex: Euro news! And with other devices linked to the same antenna cable, I can easily tune the others satellite channels to!

Ok I tried again and with this data in the picture below, when I go to search manual, the TV says that there is no signal!

did you get a lock on 11771 H, its the 3rd entry in list little higher frequency