SamyGO

Samy Go finaly works now!!!!
The info of BadBull was the solution !!! Thanks alot
I wanted to give up, but that was the decisive Tip
Perhaps we could include this tip in the first thread. My firmware version is 2110.1
Prefer again point out, as samygo once worked and did not work anymore after restart, I could prevent with putty when I entered via telnet command "reboot".
I do not know why but when I have made with the remote control the tv off and on, samygo root was history
Today I was able to bring to the root the first time to start, immediately after the root is not restarted with remote control but had the power outlet quickly switched off and on again. Root works!!!!
Maybe that has something to do with the error when you start Samygo !?

Thanks to everyone who helped me

A new (edited) root would be great to work out-of-the-box for newer firmwares of F63xx.

BadBull wrote:A new (edited) root would be great to work out-of-the-box for newer firmwares of F63xx.

Advice of not to upgrade already exists for a long time

Hello,

I have problems to root my UE32F5570 with T-MST12DEUC-2105.0 Firmware. I did the steps described in the first post. When I launch the SamyGO-F-SM-MST-Fix from the SmartHub there are some ?[NO]? during the execution.

Existing ?/dtv/SamyGO_OK?? [NO]
Existing ?/dtv/usb/sda1/SamyGO1.txt?? [NO]
Existing ?/dtv/usb/sda1/SamyGO2.txt?? [NO]
Existing ?/mnt/rcSGO?? [NO]

Everything else is ?[OK? but I don?t get root access. I also tried to use another USB disk and another USB port on the TV but it doesn?t work. I use LAN Connection and the OTN Support is disabled in the service menu. I also tried the other data.zip and the run.sh but the TV is not writing a log file on the disk. What else can I do to get the TV rooted?

try this: viewtopic.php?f=70&t=7982&start=1440#p77892 and this: viewtopic.php?f=70&t=7982&start=1440#p77895

thanks for your reply.
I did a factory reset in the service menu on the TV. Then I created a 1GB partition on the usb disk and I used the data.zip with sleep 120. But I only get the same screen again with the [No] when I start the SamyGO-F-SM-MST-Fix from the SmartHub and after reboot nothing is happening and I don't have root access.
I also replaced the run.sh but I don't get a sam.log.
What else can I do?

Take another Usb Stick (Sandisk work well)

thanks for your reply.
I already tried 3 different USB Sticks: intenso, poppstar and another one with and without 1GB partitions.

args wrote:intenso, poppstar and another one

Don't you have any of quality? Guessing "another one" is worst than the 2 others

no I don't have any other USB Sticks. Normally the intenso and the poppstar should be good usb sticks