SamyGO

I have try re-install Samygo root now if I use putty with ip: 192.168.1.15 port: 2023 and telnet there is connection but i read:
/bin/sh: can't access tty; job control turned off
VDLinux#> /bin/sh: can't access tty; job control turned off
VDLinux#>

Why?

It`s normal. Your telnet is awaiting commands.

juusso wrote:It`s normal. Your telnet is awaiting commands.

Therefore now works right?

if you can input commands and get output, then yes, it works. Be careful.

I have try a solution I use webinterface instead telnet.......
I connect with browser:
http://192.168.1.15:1080/phpsysinfo/shell.php
then i put:
user: user
password: pass
Now work
Now, What i do to install oscam?

Told you from the beginning: half-root, you lack nearly all modules due to too old fw. You should have netcat on 1023 too if that makes you happy
Well, I think it shouldn't prevent oscam from being installed. Only known source is here

Btw, remember?

zoelechat wrote:Told you from the beginning: half-root, you lack nearly all modules due to too old fw. You should have netcat on 1023 too if that makes you happy
Well, I think it shouldn't prevent oscam from being installed. Only known source is here

A last information when i do: chmod +x samyGOso oscam-r9003-samygo ntpclient i reiceive this: chmod: invalid mode x.....Why i can't change permission?

Because you lack "everything". Tried 755?

(no point in trying to install non-MST libOscam...)

Is guide good: viewtopic.php?f=63&t=6685

cat /.version X10P 0070" KERNEL MODULE VERSION : "0063.0715, DTV, X10P, release, DEU_BRANCH