SamyGO

Hi folks, I'm new to the forum. I've been searching around on the internet trying to find eeprom reset instructions for this particular hotel TV. Like many of you, I made some helpful changes in the configuration that put me into a continuous reset loop, happening so fast that no other commands are recognized. I did find a couple of folks including Heidemacker on YouTube who showed a very easy way to cross lines on the circuit board. But his board, and pretty much every other one I've seen while checking posts is different from mine. I've attached two pictures to show the overall board and it's "TF" designation, and the detail of the only place where I see the eeprom mentioned. Unfortunately that place where it's mentioned it doesn't include a reset line. I'm asking at this point because I've tried the various suggested methods of pressing keys on the remote without success.
Thanks in advance for helping!
Vidtode

A reset line?
Probably have a look there:
viewtopic.php?p=101828#p101828

I like to say thanks to the people who made suggestions. None of them worked. The TV refused to exit its restart loop. I have a partial workaround. I'm leaving the SDA line tied to ground permanently. In this mode I can turn the unit on and off and I can press the source button on the remote to manually select the HDMI input that I want. For some odd reason the system is permanently stuck in the Croatian language, and the option to change the language is disabled. But I'm not planning to do anything else with it but use it as a basic monitor.