How to know which Firmware is running on the TV?
Posted: Wed Jan 18, 2012 12:14 am
I cannot understand which Firmware is running on my EU55D7000.
Where can I ffind this information?
Where can I ffind this information?
SamyGO
Samsung TV Firmware on the GO
https://forum.samygo.tv/
How to know which Firmware is running on the TV?
Page 1 of 1
Re: How to know which Firmware is running on the TV?
Posted: Wed Jan 18, 2012 7:23 am
Yes, its the latest supported version.
Re: How to know which Firmware is running on the TV?
Posted: Wed Jan 18, 2012 9:22 am
Thank you,
I'm 001013 and I hope I'm on the lucky side.
But in the list of compatibility are reported different firmwares (T-GAS6DEUC, T-GAS6DAAC,T-GASAKUC, T-GASDEUC, T-GAPDEUC, GAP8DEUC...).
How can understand which kind is installed on my tv?
Maybe I can read it in the service menu, but when I give the sequence info-menu.mute-power it just switches off.
Is there any tutorial on how to move the first steps, i.e. identifying the FW version and take control of the TV?
I'm 001013 and I hope I'm on the lucky side.
But in the list of compatibility are reported different firmwares (T-GAS6DEUC, T-GAS6DAAC,T-GASAKUC, T-GASDEUC, T-GAPDEUC, GAP8DEUC...).
How can understand which kind is installed on my tv?
Maybe I can read it in the service menu, but when I give the sequence info-menu.mute-power it just switches off.
Is there any tutorial on how to move the first steps, i.e. identifying the FW version and take control of the TV?
Re: How to know which Firmware is running on the TV?
Posted: Wed Jan 18, 2012 9:28 am
First switch tv off and just then:
INFO MENU MUTE POWER
INFO MENU MUTE POWER
How to know which Firmware is running on the TV?
Posted: Thu Jan 19, 2012 2:19 am
Yesss! T-GAPDEUC-1013.3
It's quite below 1019, so should be very ok.
Thanks a lot for supporting me.
I'd like to put one last question and then I'll take my time to understand more before proceeding to experiment with Samygo:
I'd like to turn OTN off as recommended to avoid surprises.
I entered the option menu, but I couldn't enter the sub-option menu to change the OTN setting. I was very afraid to mess up things and didn't dare to touch anything but arrows and the enter keys on my remote.
Which keys on the remote I need to use to reach the OTN option and change the setting? (and what does it means "otn"? maybe "on the network"?
Thanks
It's quite below 1019, so should be very ok.
Thanks a lot for supporting me.
I'd like to put one last question and then I'll take my time to understand more before proceeding to experiment with Samygo:
I'd like to turn OTN off as recommended to avoid surprises.
I entered the option menu, but I couldn't enter the sub-option menu to change the OTN setting. I was very afraid to mess up things and didn't dare to touch anything but arrows and the enter keys on my remote.
Which keys on the remote I need to use to reach the OTN option and change the setting? (and what does it means "otn"? maybe "on the network"?
Thanks