SamyGO

I'm trying control a UN46D6000H via Ex-Link through a Crestron control system. Does anyone know if this is possible? My control specs reference this firmware - T-GAP8AKUC-1022.1 (or 001022), but I was not able to successfully load it to the display. I followed the instructions, but there were no firmware files found on my USB stick. I also enabled rs232 control (Debug) in the tech menu, but am not sure if I need to upgrade firmware. Currently I'm running T-GASAUSCB-1007.0. Any insight would be greatly appreciated! I'm obviously new to the SamyGO community, but find it very cool. I can't risk bricking this display though because it's not mine! I have 90 more to configure too, so hopefully someone can help me with this. Thanks in advance.

I don't know about D series, but B series you can control only in uart mode.