Page 1 of 1
PN64F8500 reboots soon after Widget run
Posted: Tue Sep 23, 2014 6:54 pm
by gunnersinclair
Firmware 1120 - TV reboots a few minutes after running the samygo widget. I can telnet in up until that point. In the few minutes of access I have, what can I collect to troubleshoot?
I disabled watchdog - then the TV just becomes unresponsive and needs a power cycle.
Thanks!
Re: PN64F8500 reboots soon after Widget run
Posted: Tue Sep 23, 2014 6:58 pm
by juusso
possible some of modules are not ok for your tv.
Re: PN64F8500 reboots soon after Widget run
Posted: Fri Sep 26, 2014 8:53 pm
by gunnersinclair
OK, so what do I need to do?
Re: PN64F8500 reboots soon after Widget run
Posted: Mon Sep 29, 2014 8:00 pm
by gunnersinclair
Can I look at a log somewhere and see which module is no ok and remove it? Or is this TV not supported?
I am happy to debug - just not sure where to go from here in the limited few seconds I can poke around.