Help for exlink serial connection

tempinbox · Post by **tempinbox** » Sat Dec 10, 2011 12:48 am

yes i cross tx and rx and i get the command that i send on consolle so this i think means that it works right?

nspierbundel · Post by **nspierbundel** » Sat Dec 10, 2011 8:26 pm

Do the commands work?
Seeing a command in serial box.like puty doesnt mean it works, try without the cable and see if you see the commands as wel

And if it does work please share the sollution

Post by **juusso** » Sat Jan 07, 2012 6:36 pm

Take PL2303 cheap adapters from ebay. cp2102 will not work. Also don't need any max232 ...
Only one gnd is needed.

Post by **juusso** » Tue Jan 24, 2012 5:17 am

Swap tx and rx. Sometimes it helps

BTW, rs232 must be set to debug in service menu, else you don't get any character even on working cable ...

Post by **juusso** » Tue Jan 24, 2012 8:53 pm

This means - your connection parameters are wrong. Either speed, or flow control or smth other...

SamyGO