HELP-PVR Recording over Samba for D-Series MSTAR

[DEUS]

OK just try to use the NFS Recording Page to setup the rest of your stuff. I did that a little bit different (see brainstorm). you need a PVRImage file set up in 04_04.vusb.init.remi71 and this needs to be mounted correctly and some content in the image. or a usb partition with the .PlaceHolderDO-NOT-REMOVE file should work too. but this is just from a quick look over the file.

[brunogts77]

Hi deus but this works for samba?

[DEUS]

it should work as far as i remeber, the difference is just the 80_80 for the SMB share the rest is the same as NFS, NFS is prefered because of performance and so on.

[brunogts77]

I'm a little confused ... In Brainstorm says so much that I do not know what to do?

[DEUS]

Ok then let me ask, do you want to use a USB drive connected to your TV, for pvr you need one, you should have a xfs partition on it with 1,5 gb storage. Then the placeholder file needs to be on that partition.
The brainstorm part is only tested on arm but might work on mstar to, no USB required because uses vusb but some storage on mtd_down

[brunogts77]

Ok then let me ask, do you want to use a USB drive connected to your TV, for pvr you need one, you should have a xfs partition on it with 1,5 gb storage. Then the placeholder file needs to be on that partition.
The brainstorm part is only tested on arm but might work on mstar to, no USB required because uses vusb but some storage on mtd_down

Good evening. I wish I could record without using usb. What should I do?

[brunogts77]

The brainstorm part is only tested on arm but might work on mstar to, no USB required because uses vusb but some storage on mtd_down

What do you mean by "but some storage on mtd_down"????

[DEUS]

arround 20MB for a xfs partition image when you mount it via Vusb it will be an 1,5GB partiiton it is everything described there

[brunogts77]

arround 20MB for a xfs partition image when you mount it via Vusb it will be an 1,5GB partiiton it is everything described there

But I need to modify VUSB? How do I increase this space?(20MB)

[brunogts77]

When I run 02_04_vusb.vpvrimage.init, VUSB disappears. When I run manually vusbpvrimage in web-cgi the message appears:

Code: Select all

cat: can't open '/sys/block/sd?/device/model': No such file or directory