I did all the instructions, after reboot everything worked.
Again turned on the tv with flash drive and got a black screen.
Here's the current boot log after all the manipulations.
Code: Select all
=================================
Samsung Bootloader Infomation
release ver : 1004 Release
etc :
=================================
UART2 is used to debug mode(0)
load kernel start, size : 131072 + 2883584 byte
load_cmac()[918 line]: entry->first_blk = 1, entry->no_blks= 1
1024 bit RSA Sign/Verify Test Success.
authentication success
XIP Kernel Image ...
Starting kernel ...
[SELP] preset_lpj manual setting 175616
================================================================================
SAMSUNG Mstar Kernel
Version : 1004.84(RELEASE)
================================================================================
init started: SELP-BusyBox v1.6.0-VD Linux SELP.4.2.1.x (2010-03-25 09:52:34 KST) multi-call binary
starting pid 21, tty '': '/etc/rc.sysinit'
/etc/rc.local start!!!!
##################################
VDLinux 1.1.1.x Mstar RootFS ver
1004
Used kernel ver(module is builed)
1007.88(RELEASE)
##################################
starting pid 32, tty '': '/bin/cttyhack'
/etc/profile start!!
/mtd_rwarea/PartitionSwitch_0_0 is detected...
1st Partition is selected....
_mod_sys_init.176 ioctl
== Start exeDSP ==
/mtd_exe/rc.local start !!!!!
insmod: cannot insert '/mtd_exe/samsung_mstar.ko': File exists (-1): File exists
******************************************************
Application running is failed..
SW image is stopped..
******************************************************
SELP#> [CIP_KERNEL] >>> (/bin/authuld) file is successfully authenticated <<<
[CIP_AUTHULD] ====================================================
[CIP_AUTHULD] Authuld Version : 1.1 : REL
[CIP_AUTHULD] ====================================================
[CIP_KERNEL] Success!! Authuld is successfully completed.
Code: Select all
SELP#> 10041004
-/bin/sh: 10041004: not found
SELP#>
