Modifying /mtd_exe in-place

Here is information about customize your B series firmware..:!:This forum is NOT FOR USER questions or problems but DEVELOPER.
Post Reply

User avatar
erdem_ua
SamyGO Admin
Posts: 3126
Joined: Thu Oct 01, 2009 6:02 am
Location: Istanbul, Turkey
Contact:
Contact erdem_ua

Re: Modifying /mtd_exe in-place

Post by erdem_ua »

That partition is in READONLY flash device. So you cannot write it.
You needed to rewrite complete partition with changes.(Like older exe.dsp)
Please read Manually Flashing wiki page.
Top
nbd
Posts: 161
Joined: Wed Jan 13, 2010 12:02 pm

Re: Modifying /mtd_exe in-place

Post by nbd »

I got the same libPluginTvOEM.so missing when I tried to manually start exeDSP within telnet session. After a while I found the libraries (under the widgets or something like that) and added them to LD_LIBRARY_PATH. Then exeDSP started but it failed to function properly. Dunno if it's even possible to start it successfully from the telnet session.
Top

Post Reply

Return to “[B] Firmware”