- SamyGO Project Donor
- Posts: 590
- Joined: Tue Aug 23, 2011 9:03 am
- Location: Hamburg
FYI: you can close your ssh session with SamyGO with
Code: Select all
Still wasn't able to get my hands on one of these mainboards. Any alternative to get PVR function going - like a board from a C6500 maybe?TOMillr wrote:Can anyone point me to a webstore or ebay buyer who still sells a replacement mainboard for upgrading my C6000?
if upgrading from c530 to c650 works (I give it a try) - do i need a different remote control?
To the right.
When I power up the tv, the picture is all distorted (see attached picture). After a couple of seconds the tv then shuts down and reboots again. This circle continuos until I pull the power plug.
Any idea what's going on here?
http://wiki.samygo.tv/index.php5/UnBric ... OM_chip.3Fjuuso wrote:Try to reset EEPROM, maybe it stuck on values for C6000
Before I do that, I'd like to make sure that the board itself is working properly. The BN94-03406M board is a replacement part for a UE40C6700 tv. Should that one work with my UE46C6000?
I also don't understand how some C6000 values should have made it's way to the EEPROM on the new C6700 board.
My fault, it isn`t. I was thinking something else.TOMillr wrote:I also don't understand how some C6000 values should have made it's way to the EEPROM on the new C6700 board.
But anyway, eeprom reset may help in this situation. You don`t need to solder anything, it is enough to make short circuit with some metalic toy at the boot time of tv.