[How To] Get root access on F series

[LS29]

You have to set "OTN support" to OFF in service menu.

To access service menu, TV being off use remote control:

[MENU] [MUTE] [POWER]

Be careful!! Left-right keys change values without confirmation, use only up-down-enter until you reach desired option:
Option->MRT Option->OTN Support, set to OFF by pressing right key
Reboot TV

Any F owner (I'm not) could correct me if I'm wrong somewhere. I just retrieved info from forum that anybody could find by searching a bit

Hi,
Thanks for reply Zoe, but I don't have OTN SUPPORT in MRT OPTION,
and now, Who I resolve this??

[greenhorn]

OTN Support (Service Menu -> "Control" -> "Sub Option" -> "OTN Support" -> Off) to avoid future firmware updates.

[sectroyer]

OTN Support (Service Menu -> "Control" -> "Sub Option" -> "OTN Support" -> Off) to avoid future firmware updates.

On E no such option, right ?

[gjstroom]

OTN Support (Service Menu -> "Control" -> "Sub Option" -> "OTN Support" -> Off) to avoid future firmware updates.

On E no such option, right ?

I don't have this option either on my F8000 T-FXPDEUC 1118.0.
I updated a couple of weeks ago, just when the tv arrived. I didn't read about the update warning...
I had a look in the service menu today and some things look interesting.
control, sub option, option swu
You can change otn server type (operating/development) and ont test server (off, a-e zone)
SWU reset, what does it do ???
Maybe some interesting settings to preform a software downgrade ?

[juusso]

I advice you touch any of these options. Just only if you see otn off you could switch updates off.

[gjstroom]

I advice you touch any of these options. Just only if you see otn off you could switch updates off.

Already did touch them, the options are listed in my previous post.

[greenhorn]

As I said...it is accessible only in F series. No such a thing in the ES. Also, you can access only if you enable the extended menu. It did it with IR blaster.

[LS29]

OTN Support (Service Menu -> "Control" -> "Sub Option" -> "OTN Support" -> Off) to avoid future firmware updates.

Thanks for your attention greenhorn,
but i dont have this option too, see



who i resolve this??

[matrixabc]

OTN Support (Service Menu -> "Control" -> "Sub Option" -> "Option_SWU"->"OTN Server Type" -> In Operating to Off

[greenhorn]

guys...you don't read all I write. you have to use the procedure for opening the extended service menu. then you are be able to do the change.