Hi, to all i'm new on this forum , but i think i will find some good answers... i have this tv working ok , yesterday after power down , tv start bootloop with SMART TV logo.....i have read this forum about reset, i have made an Wired ExLink cable with RS232 USB to UART TTL Cable PL2303 Converter module like here http://wiki.samygo.tv/index.php5?title= ... BD_players connected to a VGA connector....and in LINUX UBUNTU.. i got on XTERM what read from fault mainboard........i forget ,.. a friend of mine gave to me a good mainboard but from UE40D5000 tv wich when replace with my fault board tv was working ....in this case i have read with pc adapter to vga in LINUX..........Readings are repet forever with fault board , and with good board only when i make power off from remote and again on.......
MY question and problem is that i don't know to interpret the both flies that are read from both boards.......i will apreciate any help....thank you very much..
TV SAMSUNG UE40D5500RW bootloop
TV SAMSUNG UE40D5500RW bootloop
You do not have the required permissions to view the files attached to this post.
Re: TV SAMSUNG UE40D5500RW bootloop
Hi, everyone, today i have made some tests on tv with fault mainboard, and reset few times the eeproms and plug in and out the cable and...surprise the tv start-up normaly...i ve done shutdown , power-up in service mode....factory reset...power off....and again service mode and then watchdog off...powerdown and after , on and tv it is ok now...what surprise for me.........thanks for all who read my topic..hope it will help....all the best..