Samsung LE40856S1M Black Screen!

[HerculesDK]

Dear Board of AV experts and enthusiasts,

I have a Samsung LCD LE40A856 Full HD TV, which I bought in 2009. The TV has been working fine, but I noticed that there was a line down in the left side of the panel, when I did a cold boot up that disappeared after 10 minutes or so. This was not really an issue, but then I moved and have not used the TV for long. The times when I did turn it on it worked fine. But for some weeks ago I had to connect my PS3 to the TV using the HDMI port and it started to act funny. It just showed a black screen when I tried finding the PS3 and started to freeze in the menu. But the TV signal was fine. The freezing got worse and the TV started to operate very slowly so I switched the TV off. Since then it clicked a few times with a black screen and I haven?t been able to test the sound. The panel sounds work, but there is nothing on the display. This is what I have tried so far:

1) Checking the capacitors ? I couldn?t find any faulty ones, but I changed them all on the power supply.

2) Checked and changed the two 450v 68uf ones also even though they looked fine.

After doing the above mentioned the situation is the same. I am starting to suspect that it might be the T-con board or the main board; however I do not have the means to test these. I did notice today that before resetting (it is in a kinda boot loop) the LCD TV does light op before shutting down. So I do not think that the panel is dead, which is good news (if I am right). The TV only clicks once on startup and nothing else. However, I noticed that the volume up touch sensitive button on the TV set on the front is blinking all the time. I?ve tried calling Samsung, but they did not know what it meant! I do believe that this is some kind of a diagnostic problem indicator, which I do not know the meaning of.
Is there anyone that can help me with my Samsung LCD TV set? The TV is unplugged at the moment, but I wish I somehow could reset the BIOS/firmware or the eeprom or so. It does have a Service port, but I don?t know how to use it? It also has an Ethernet port, but I don?t know how to use it in this situation.

I've created a PDF file with all the pictures that you've asked for. Please notice that I done the following things so far:

1) Changed capacitors ? small ones and two big ones on the power supply.
2) Created two ?bridges? on the T-con board to see whether it was those fuses that needed to be changed.
3) I do not have a multimeter to check things; however, I had the fuses checked on the power board by an electronic shop (only three).

I dont even think any of them were faulty. I spoke to a guy in the electronic shop, where I bought them and he and the electrician came to the same conclusion as me that they probably weren't faulty. But I changed them all just to be safe.

I hope to hear from you soon and hope that someone can help me please.

Link: http://www.filefactory.com/file/6ixh..._w_Remarks_pdf

PS.: I suspect that there might be some kind of short circuit, but I am not sure.

[HerculesDK]

Also the 4th button from the right - the volume up button (+) is blinking all the time. Does anyone know what this means?

[HerculesDK]

However, I tried starting the LCD TV without plugging in the cable for the T-con board and now the source button on the touch screen panel is blinking instead of the 4th button. Which makes me think 2 things:

1) its either the mainboard - a short circuit in that
2) or the T-con board, but I cant see any "problems" with it? Any marks or so.

Perhaps it could be some 82k ohm resistor on the main powerboard that are broken? Does anyone have the knowledge to pin-point those on the pictures?

I've just spoken to a Samsung Tech and he said that it could be a eeprom error, which he has experienced on these models. Does anyone of you know where the eeprom chip is located and how do I reset it?