[SOLVED] UE-C6500 bricked after upgrade to T-VALDEUC 3015
Posted: Mon Mar 25, 2013 1:26 pm
I upgraded my TV - model UE37C6500UP XZT - from fimware T-VALDEUC 3007 to T-VALDEUC 3015 using an USB drive.
After the update the TV works fine for about 10 seconds then the screen shows some artifacts and the TV reboots. The process goes on forever.
Previously, when I was on 3007 firmware, I had enabled PVR and Gemstar (GuidePlus) through Hotel/Service mode following the SamyGO Wiki.
Here's the process in detail:
1. I downloaded the firmware from Samsung official site and I copied and extracted the file directly into the USB flash drive.
2. I plugged the USB pen into the TV. The TV recognised the update and began the update process.
3. When the update reached 100% the TV reeboted and the problem started.
In the first 10 seconds after the reboot I can use the remote control - i.e. to turn up the volume, change the channel or enter the settings menu - but I don't have enough time to edit any setting.
The TV is completely unusable.
Do you have any suggestions on how to solve the problem?
After the update the TV works fine for about 10 seconds then the screen shows some artifacts and the TV reboots. The process goes on forever.
Previously, when I was on 3007 firmware, I had enabled PVR and Gemstar (GuidePlus) through Hotel/Service mode following the SamyGO Wiki.
Here's the process in detail:
1. I downloaded the firmware from Samsung official site and I copied and extracted the file directly into the USB flash drive.
2. I plugged the USB pen into the TV. The TV recognised the update and began the update process.
3. When the update reached 100% the TV reeboted and the problem started.
In the first 10 seconds after the reboot I can use the remote control - i.e. to turn up the volume, change the channel or enter the settings menu - but I don't have enough time to edit any setting.
The TV is completely unusable.
Do you have any suggestions on how to solve the problem?