D7090: no NC/Telnet access

[Hardi]

Hi,

i have a UE40D7090 with FW1015 and SamyGo Widget installed. My TV network configuration is done manually (no DHCP) to have always the same IP in home network. I can use NFS to share video from my NAS and i am able to connect to TV via FTP. But i am not able to connect via nc/telnet to run some linux commands.
So i did a portscan from my PC to the TV's IP and see tha only Port 23 and 80 is listening, no NC/Telnet Port.

Do i have to do some other configuration, eg. in Servicemenu to get commandline access?
How do i use the SamyGo Console opening when i start SamyGo widget a second time?

regards Hardi

[arris69]

Hi,

i have a UE40D7090 with FW1015 and SamyGo Widget installed. My TV network configuration is done manually (no DHCP) to have always the same IP in home network. I can use NFS to share video from my NAS and i am able to connect to TV via FTP. But i am not able to connect via nc/telnet to run some linux commands.
So i did a portscan from my PC to the TV's IP and see tha only Port 23 and 80 is listening, no NC/Telnet Port.

Do i have to do some other configuration, eg. in Servicemenu to get commandline access?

How do i use the SamyGo Console opening when i start SamyGo widget a second time?

regards Hardi

then try to make netcat connection to port 23. but wonder why your "port scanner" not shows you port 21 too