I tried to make Telnet and Remote LAN Control autoloader.
Because there is no current ready to use script and config to do this I tried to do it following the examples linked in Wiki and in this forum too.
After flashing the TV's light still flash five times and then the light is on. But the TV itself stays black .
I read something about the workarounds and u-boot, also about the ExLink Interface here.
Unceremoniously I bought a PICAXE AXE027 cable (PICAXE-Programing Cable USB to Serial).
Now, I tried to follow the instructions and launch the console. But it doesn't work.
Pages of scattered characters occur.
I cannot start the Service Menu
Before I begun, I set the RS232 to Debug and the other changes recommended in the manual here.
What can I do to recover my TV? I have no trust in me to make the EEPROM hardware reset, powered on open TV.
I live 50 km from Munich and I read here another User in Munich.
Maybe the cable is wrong wired?
Any ideas?