Firmware 1120 - TV reboots a few minutes after running the samygo widget. I can telnet in up until that point. In the few minutes of access I have, what can I collect to troubleshoot?
I disabled watchdog - then the TV just becomes unresponsive and needs a power cycle.
Thanks!
PN64F8500 reboots soon after Widget run
-
gunnersinclair
- SamyGO Project Donor
- Posts: 3
- Joined: Wed Sep 10, 2014 3:36 pm
Re: PN64F8500 reboots soon after Widget run
possible some of modules are not ok for your tv.
LE40B653T5W,UE40D6750,UE65Q8C
Have questions? Read SamyGO Wiki, Search on forum first!
FFB (v0.8), FFB for CI+ . Get root on: C series, D series, E series, F series, H series. rooting K series, exeDSP/exeTV patches[C/D/E/F/H]
DO NOT EVER INSTALL FIRMWARE UPGRADE
Have questions? Read SamyGO Wiki, Search on forum first!
FFB (v0.8), FFB for CI+ . Get root on: C series, D series, E series, F series, H series. rooting K series, exeDSP/exeTV patches[C/D/E/F/H]
DO NOT EVER INSTALL FIRMWARE UPGRADE
-
gunnersinclair
- SamyGO Project Donor
- Posts: 3
- Joined: Wed Sep 10, 2014 3:36 pm
Re: PN64F8500 reboots soon after Widget run
OK, so what do I need to do?
-
gunnersinclair
- SamyGO Project Donor
- Posts: 3
- Joined: Wed Sep 10, 2014 3:36 pm
Re: PN64F8500 reboots soon after Widget run
Can I look at a log somewhere and see which module is no ok and remove it? Or is this TV not supported?
I am happy to debug - just not sure where to go from here in the limited few seconds I can poke around.
I am happy to debug - just not sure where to go from here in the limited few seconds I can poke around.