d6200 change to d6100

[aela111]

Hello my tv is d6200
i change it to the d6100 over the service menu
so now i have the pvr working
recorded on hdd is ok but i cant record on usb
can i fix it?
in my service menu i saw 3d support-3d only
when i change to another models its
3d support-sparma or pnapoli or napoli
can some one told me what is this?
and if i cuold make my tv work 2d to 3d ?
another thing is in another models in the service menu the web browser
is shown like all the apps but its dont work
can we fix it ?
thanks fot everybody

[erdem_ua]

Your device doesn't have IR led to convert your TV into 3D mode.. So it's useless, at least without extra hardware.
And PVR require speedy USB flash. I think your USB write speed is too low (generally most of them slow such a job) to record such a stream.

[aela111]

What is this ir led ?
I saw in my service menu
ir -off should I change it yo on?
and how can I enter to the advanced?
I try to enter but nothing happened.
I saw it the wiki something about this to press on zero four times
I do it but nothing.
thanks for the help

[julianbb]

I also tried to enable 3d on my c650 changed in c750 but it's not easy. 3D Video signal is decoded inside the lcd panel and the syncronize signal (Vsync) shold be present at LVDS connector IF your LCD panel have this pin... after that you have to send this signal to 3Dglasses via infrared interface ..
So first try to find your tv service manual and check if your model hardware can be upgraded...

[aela111]

But my 3dglasses are working with bt
so what I need to find lvds?

[julianbb]

Sorry, my mistake
Your tv is allready 3d tv( http://www.reviewbloger.com/samsung-ue46d6200-review)
so you ask just about the 2d to 3d conversion ? then you can try "3d support-sparma or pnapoli or napoli"
but also this can brick your tv ... better wait to find servicemanual and check hardware compatibilty
Did you have the 2D>3D button ? (is also blue or "D" under the exit button)

[aela111]

yes i have it
in the d6200 when i push the button i get sbs or upand down
and if i change tv to d6500
i get the 2d to 3d i push the button the screen become green but i heard voice .

[julianbb]

So... Thats mean your graphic engine does not support 2d to 3d conversion Or the settings in service menu at 3d options not match your hardware...
Even in the worst case you`l be ok not talking about your tv

[aela111]

so i need to check in the service manual in my tv
and in a tv that all ready have 2d to 3d
and that in the worst case ...
And what about THE WEB BROWSER i saw it in the smurt hub but its not work
jus blinking when i try to run it

[julianbb]

Waw!!! when apeared ? after change model ?
Try to change country to USA or GB with ff 289 rw and let smarthub to update widgets