Unbrick 55ES7090
Posted: Fri Dec 26, 2014 9:08 pm
Hi,
Last week I installed the new evolution kit (sek-2000) in my 55ES7090 and it killed my TV.
As the last step of the install wizard it asked to update the software (I guess the TV firmware) and I went out of the room.
When I came back the TV was turned off. When turning it on it works fine for ~15 seconds and then turns off again. (with and without evo kit)
I think something went wrong during firmware upgrade and I'm looking for ways how to recover it.
15sec where enough to do a factory reset in the service menu, but the problem is still there.
Is there a way to interupt the normal startup and reflash the firmware ? Any idea how this can be fixed .
Samsung Support was of no help, they just claim that the evolution kit can't be the reason and that I should send the TV for repair (on my own cost)
Thanks a lot.
Last week I installed the new evolution kit (sek-2000) in my 55ES7090 and it killed my TV.
As the last step of the install wizard it asked to update the software (I guess the TV firmware) and I went out of the room.
When I came back the TV was turned off. When turning it on it works fine for ~15 seconds and then turns off again. (with and without evo kit)
I think something went wrong during firmware upgrade and I'm looking for ways how to recover it.
15sec where enough to do a factory reset in the service menu, but the problem is still there.
Is there a way to interupt the normal startup and reflash the firmware ? Any idea how this can be fixed .
Samsung Support was of no help, they just claim that the evolution kit can't be the reason and that I should send the TV for repair (on my own cost)
Thanks a lot.