[SOLVED]Problem with CI+ after Downgrade

mupsi210 · Post by **mupsi210** » Mon Jul 09, 2012 2:02 pm

Hello to all,

i downgraded my ue46D8000 with the Firmware Downgrade D-Series (SamyGO Proof of Concept) from Firmware T-GAP8DEUC-1022.1 to T-GAP8DEUC 1015, to use later HbbTV.
It was all very simple and well described. Thank you for that. Unfortunately, the CI + module by smardTV.com can not be authenticated. Could this be a problem of the new firmware ?
There were many problems with this module and Samsung tvs, that you can read in the forums.
So if the firmware is the problem, there is a possibility to upgrade it again ?

Post by **juusso** » Mon Jul 09, 2012 2:12 pm

you can always upgrade to other firmwares using USB and regular firmware upgrade way.

mupsi210 · Post by **mupsi210** » Mon Jul 09, 2012 3:07 pm

Unfortunately no, I've tried it with the firmware 1023.1 from Samsung Site on the USB Stick. if i click on USB Update I get the message " no newer Version" on the screen the same is with the internetupdate.

mupsi210 · Post by **mupsi210** » Tue Jul 10, 2012 7:40 am

ah yes, my mistake

, I took another USB stick and the upgrade worked.
And the other problem is the age of the firmware, the old firmware (T-GAP8DEUC-1015) cannot work together with the new software of the CI+ Modul.
I've tried the new version and the CI + module has been detected.
So, I would have to downgrade the software of the CI + module to get to the success, but I think that's not possible.

Sammy · Post by **Sammy** » Tue Jul 10, 2012 9:54 am

I had a similar problem with the old firmware, in that a lot of my Sammy widgets would not work...upgraded back and all was fine..

It Seems with the newer tvs coming out now that even 1018 firmware is too old.

vulcan82 · Post by **vulcan82** » Fri Jul 13, 2012 8:48 am

I managed to downgrade To 1015 and update to 1018. THe samygo app remained installed in some way, all the time, I don't know how. Now I have a problem with the CI+ module, which doesn't seem to authenticate. Did Samy messed it up ? What should I do to fix it ?

Sammy · Post by **Sammy** » Sat Jul 14, 2012 6:00 am

Install the latest firmware for your tv, and wait until Sammy go is compatiable with later firmware.

Keep an eye our in the E series forums

vulcan82 · Post by **vulcan82** » Sun Jul 15, 2012 1:12 pm

When I boughr the tv the fw was 1018, i think, so it should work. Did the CI+ module updated it's software. It didn't noticed me.

SamyGO

[SOLVED]Problem with CI+ after Downgrade

[SOLVED]Problem with CI+ after Downgrade

Re: Problem with CI+ after Downgrade

Re: Problem with CI+ after Downgrade

Re: Problem with CI+ after Downgrade

Re: [SOLVED]Problem with CI+ after Downgrade

Re: [SOLVED]Problem with CI+ after Downgrade

Re: [SOLVED]Problem with CI+ after Downgrade

Re: [SOLVED]Problem with CI+ after Downgrade